Site Logo
part store icon
  • >SMT Equipment
    • Stencil Printers
    • Pick and Place
    • Reflow Ovens
    • PCB Inspection System
    • Custom Equipment
  • >Through-Hole Systems
    • Wave Solder Machines
    • Selective Solder Systems
    • Solder Fountains / Rework
    • Component Counters
    • Lead Formers
  • Industries
    • Contract Manufacturers
    • OEMs
    • Universities
    • Aerospace/Defense/Military
    • R&D/Product Development
  • Support
    • Learning Center
    • Product Training
    • Technical Workshops
    • Service and Support
    • File Library
  • About us
    • Our Team
    • History
    • Customers
    • Made in the USA
    • News and Events
  • Contact Us
Close
  • >SMT Equipment▲
    • Stencil Printers
    • Pick and Place
    • Reflow Ovens
    • PCB Inspection System
    • Custom Equipment
  • >Through-Hole Systems▲
    • Wave Solder Machines
    • Selective Solder Systems
    • Solder Fountains / Rework
    • Component Counters
    • Lead Formers
  • Industries▲
    • Contract Manufacturers
    • OEMs
    • Universities
    • Aerospace/Defense/Military
    • R&D/Product Development
  • Support▲
    • Learning Center
    • Product Training
    • Technical Workshops
    • Service and Support
    • File Library
  • About us▲
    • Our Team
    • History
    • Customers
    • Made in the USA
    • News and Events
  • Contact Us
Home > Support

Support

  • Learning Center
  • Product Training
  • Technical Workshops
  • Service and Support
  • File Library
Made In USA emblem


Selective Soldering Process - Recommended Parameters

Download pdf version


Solder Temperature

  • Measure and verify regularly that the set solder temperature is stable.
    Recommended: Check every 2 weeks.

Preheater

  • Measure and verify regularly that the set temperature profile on the top and bottom of the PCB is stable.
    Recommended:  Check every week or every time you change a product over.

Flux

  • Check the flux quality. Since only a small amount of flux is used for selective soldering, make sure the flux has not expired.
  • Make sure maintenance is done on the Spray Fluxer.
  • Make sure the Fluxer is spraying correctly.
    Recommended: Should be checked every shift.

Nozzle

  • Monitor wave height
    Recommended: Clean wettable nozzle 2 to 3 times per shift.

Position of the Board

  • Make sure the PCB orientation is always the same when loading the machine.

Board Warping

  • A heavily warped board cannot be controlled by the selective soldering machine.
  • Make sure the board is as even as possible.
  • If necessary, use special solder fixtures.

Lead Length of Components

  • Sometimes the leads to be soldered are cut in different working/assembly steps. Since the lead length in selective soldering is very important, make sure that the leads are all the same length.
    Recommended: Ideally all the leads should be identical in length and less than 1.5mm.

N2 Quality

  • Always check the purity of the N2.
    Recommended: N2 quality should be 5.1 (=99.999% N2)

Footer Logo
DDM Novastar, Inc 212 Railroad Drive, Ivyland, PA 18974 | Ph: 215.485.5663 Privacy Policies